(Shown Below) Your alarm input setup is now complete.
Each colored square represents one hour, the blue color means that there is no recording for that hour and the yellow means that there is recording for that hour. Then under Schedule, select the time(s) for the alarm channel that you wish to have the alarm recording set for.
In the main menu, from Setting->Event-> Alarm, you can see alarm setup interface. The record priority is: Alarm>Motion>Regular. Now select the Menu icon at the bottom of the DVR home screen. Before you set alarm setup information, please connect alarm input and alarm output cable (such as light, siren and etc).Motion Detection Setting > Alarm > Motion Detection > Event Actions > Send E-email. Alarm e-mail notification can be enabled for Motion detection, video loss or camera tamper. Make sure that the alarm settings are properly set up and Send E-mail option is enabled. The Text option is for your reference, i.e front room, shed, etc. Ensure that the device is connected to the network properly. We are using a door contact for this article so we have it set to normally closed that way when the door is opened the alarm triggers. This will be determined based on the type of sensor being used. Under the Type tab, select either N / C (Normally Closed) or N / O (Normally Open). Now select Enable under the Operation tab for the correct channel (If your alarm is connected to alarm input 1 then you will need to enable it under Ch 1). Then go to the Alarm Input tab on the left.Now select the Event Sensor option on the menu.First, select the Menu icon at the bottom of the DVR home screen.The inputs are numbered 1-8 or 1-16 depending on your DVR model and the ports labeled "GND" are a shared ground port, which means that you can connect the ground of more than one device to it. 95.99 Sale 149.99 Price 249.99 List Price You Save: 154.00 (61.60) M7B5MP-PSAA 2560x1920P Microseven (2020)Open Source 5MP (2560x1920) UltraHD POE or Wired SONY 1/2.8' Chipset CMOS 2.8mm 5MP Lens Wide Angle (150) Two-Way Audio with Built-in Amplified Microphone and Speaker plug and Play ONVIF, IR Light (On/Off in the APP) Security Indoor / Outdoor IP Camera, Human Motion Detection. Connect the alarm input device that you will be using to one of the alarm-in ports on the IO terminal block on the back or your DVR. Microseven (2020)Open Source 5MP (2560x1920) UltraHD Wi - Fi or Wired SONY 1/2.8' Chipset CMOS 2.8mm 5MP Lens Wide Angle (150°) Two-Way Audio with Built-in Amplified Microphone and Speaker plug and Play ONVIF, IR Light (On/Off in the APP) Security Indoor / Outdoor IP Camera, A.I.
0 kommentar(er)
